The Strandhögg is certainly one of the very best armour carriage products on the market and has been for a long time. US made from exceptional materials which facilitate a huge amount of modularity, and able to accept a wide range of hard plates and soft armour in the front, rear and sides in standard configuration.
The V3 is setup on the front to mount the FS Primary Pocket Panel, which is a very nice placard that uses their proprietary materials and can take common inserts, but the it mounts is using OneWrap rather than any top mounted hardware as most placards out there do.
In order to modify the front panel as per slide 2, all you need is around 18″ of 1″ width Velcro OneWrap and a pair of female QASM 1″ buckles. Cut lengths around 2″ and loop them in along the bottom of the front plate. Then a couple of strips around 3″ long will allow you to mount the QASMs in the right place for placards from other popular manufacturers.
There are much fancier or more permanent ways to do this and dedicated products from others companies of course, but these materials are pretty to get hold of and the end results works out nicely considering the low cost.
Leave a Reply